Dipol TFA 2.0 SL Manual page 13

EN
USB data transfer to PC
Enables the copying and deletion of video files
from the built-in memory card. Plug USB type C
cable to slot (11) and other cable side connect
to PC USB slot, then select this chapter and press
MENU controller (4) for confirm.
You will see the sign "Establishing connection
..." on the screen, and the device will soon be
visible as a flash drive in PC.
For prevent troubles with connection or if sign
"Replace the power source" strongly
recommended to use branded USB cable and
plug device to 2.0 USB sloth or higher in your
computer.
For exit data transfer mode turn off the device
and disconnect it from PC.
Video recording mode
You can choose either normal start or quick
start for video recording.
In normal start mode, the video recording starts
with a slight delay (up to 10 seconds) after the
"REС" button (8) is pressed to switch on the
corresponding module and load the software.
In the quick start, modules and software loading
are activated just after the pressing the "REС"
button. Videos are recorded up to 5 seconds
faster after the REC button is pressed.
The following indicators are visible in the status
bar during video recording:
REC (blinking) - recording module active
REC - ready to record
REC 00:01:20 - recording
REC Saving - internal storaging running
Note: the battery consumption is greater in the
video recording mode as well as during the quick
start.
13