Alamo Bush Hog HDC-3 Series Operator's Manual page 7

DEALER PREPARATION CHECK LIST
For NEW ZERO TURN RIDING MOWER
BEFORE DELIVERING MACHINE - The following check list should be completed.
Use the Operator's Manual as a guide. Engine has been serviced.
 Ground Cable connected to Battery Negative Pole.
 Zero Turn Mower start code communicated to Owner.

Low oil pressure light checked for operation.
 Operator interlock switches checked for operation.
 Assembly completed.
 All fittings lubricated.
 Hydraulic Reservoirs filled to Cold Fill Line with oil.
 All shields in place and in good condition.
 Roll-over Protective Structure is raised to the upright position and pinned out. This may require
the upper ROPS to be rocked forward to align the Pin-Out Holes.
 Retractable seat belt functions property.
 All fasteners torqued to specifications given in Torque Chart.
 All decals in place and readable. (See decal page.)
 Overall condition good (i.e. paint, welds)
 Parking brake checked and adjusted, if necessary.
 Steering checked and adjusted, if necessary.
 Check tire pressure.
 Warranty information has been registered on line with Bush Hog.
 Operator's manual has been delivered to owner and he has been instructed on the safe and
proper use of the Zero Turn Mower.
Dealer's Signature ____________________________________
Purchaser's Signature ____
___________________________________
THIS CHECKLIST TO REMAIN IN OWNER'S MANUAL
It is the responsibility of the dealer to complete the procedures listed
above before delivery of this Zero Turn Mower to the customer.