Table of Contents
Advertisement
P9
FINE ADJUST
The FINE ADJUST area is protected by a key combination. Focus, shapers, shaper rotation, pan
and tilt are calibrated at the factory. If there are large deviations in the calibration between the
individual headlights, this can be corrected in the FINE ADJUST menu. For more information
please contact our service.
IDENTIFY DEVICE
The RDM command IDENTIFY DEVICE can be called up or deactivated via this menu item.
8.2 Changing gobos
!
WARNING: Disconnect fixture before opening!
To open the device (from the right side) place
the spotlight on a firm base as shown in the
picture, the display (1) facing you, the tilt lock (2)
is on the right side and the spotlight head facing
away from you (3) (Or look through the grille
into the spotlight from behind and find a closed
honeycomb showing the cover to be opened).
To lift off the cover, open the four camlocks by
half a turn, lift off the cover and unhook the safety
lanyard. Now open the two knurled screws (4)
and remove the gobo insert. The following figure
(1) shows the gobo insert of the P9 Beamspot.
Check that the focus is moved direction to the
front lense
(1)
When inserting original gobos, pay attention to the markings on the gobo, the gobo holder and
the gobo wheel!
- 34 -
1
1
To change the rotating gobos remove only
the clamping ring (A) with a pointed object
replace the gobo and then put the clamping
ring again. When installing glass gobos,
make sure the white coated side faces the
front lens. Gobos that are not allowed to twist,
e.g. Logos are additionally recommended to
be secured against twisting with a drop of
silicone adhesive.
(2)
4
3
3
2 2
A
Advertisement
Table of Contents
