Control Panel - JB-Lighting P9 Beamspot Operating Instructions Manual

P9

6. Control panel

The P9 Beamspot has a graphic colour touch display that can be rotated 180° when installed in
a suspended position. The display can be rotated in the PERSONALITY MENU or via shortcut
ENTER + UP in the main screen.
All parameters of the P9 Beamspot can be set on the control panel (see menu overview page
16).
Function and operation of the display
The main menu provides information regarding the set DMX mode and, when the wireless mode
is switched on, the field strength of the associated transmitter module. "ENTER" calls up a sub-
menu or confirms an input. "ESC" is used to exit a function or a menu item. "UP" and "DOWN"
are used to navigate within the menu and to enter values.
Special areas can only be called up using a specific key combination. To do this, press and hold
the "ENTER" key and then use the opposite "ESC" key to access the menu. To exit the function,
proceed in reverse order.
This applies in the SERVICE area for the FINE ADJUST function and in the STANDALONE area
for the MODIFY, RUN and REMOTE functions.
The main menu can also be locked to prevent unintentional access. It is also locked by pressing
the "ENTER" key (keep it pressed) and then additionally locking it with the opposite "ESC" key.
From software 1.5 onwards, all functions can also be operated via the touch display.
- 14 -