Advertisement
Step 3:
Orient the Oil Cooler Guard Rear
Side (RS) (2).
Slide in the Bush spacer Delrin (3)
– 2 off, sandwiching between the
adjacent surfaces and Slide in the
M6 washer (4)-1 off, and Screw
M6x20 (5)-1 off, The Oil Cooler FS
has the threaded hole to secure
the threads of the M6 screw.
The final mounted condition of the Oil Cooler
Guard is as shown in the adjacent drawing .
Copyright By SRC
Design and Specification are subjected to change
Step 3:
Orient the Nut M6 (7) -1 off
Slide in the Nut M6 (7) – 1 off, to
the Oil Cooler Guard Rear Side (RS)
(2). has the threaded hole to secure
the threads of the M6 screw.
Page 3
Advertisement
