Troubleshooting - Zanussi ZDF1001 User Manual

3
To remove filters (B)
and (C), turn the han-
dle counterclockwise
and remove. Pull
apart filter (B) and
(C). Wash the filters
with water.
D
A
5
Put filter (A) to its ini-
tial position. Make
sure that it assem-
bles correctly under
the two guides (D).

Troubleshooting

The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the
problem.
With some problems, the display shows
an alarm code:
•
- The appliance does not fill with water.
Problem
The programme does not
start.
48
A
4
Remove filter (A).
Wash the filter with
water.
6
Assemble filters (B)
and (C). Put them in-
to position in filter
(A). Turn the handle
clockwise until it
locks.
Possible cause
The mains plug is not connected in
the mains socket.
An incorrect position of the filters can
cause bad washing results and damage
to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin poin-
ted object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits of grease
and limescale inside the appliance.
To prevent this, we recommend to run long
duration programmes at least 2 times per
month.
•
- The appliance does not drain the wa-
ter.
•
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks. Turn the
programme knob until the programme marker
is aligned with the off position.
Connect the mains plug.
Possible solution
www.zanussi.com