Hints And Tips - Zanussi ZDF1001 User Manual

gramme you want to set. Make sure that
the appliance is in setting mode.
• The programme duration flashes in the
display.
• The phase indicators of the set pro-
gramme come on.
4. Press Start. The programme starts.
• The programme duration stops flashing
in the display and starts to decrease
with steps of 1 minute.
• Only the indicator of the phase in opera-
tion stays on.
Starting a programme with delay start
1. Set the programme.
2. Press Delay again and again until the dis-
play shows the delay time you want to set
(from 1 to 9 hours).
• The delay time flashes in the display.
3. Press Start. The countdown starts.
• The delay time stops flashing in the dis-
play. The countdown starts to decrease
with steps of 1 hour.
• The phase indicators of the set pro-
gramme go off.
• When the countdown is completed, the pro-
gramme starts.
– The indicator of the phase in operation
comes on.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance con-
tinues from the point of interruption.
Cancelling the delay start while the
countdown operates
Press the Cancel button until the display
shows the programme duration and the phase

Hints and tips

The water softener
Hard water contains a high quantity of miner-
als that can cause damage to the appliance
46
indicators of the set programme come on.
Press the Start button, the programme starts.
Cancelling the programme
Press and hold the Cancel button until the
programme duration flashes.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, the dis-
play shows 0 and the phase indicators go off.
1. To deactivate the appliance, turn the pro-
gramme knob until the programme marker
is aligned with the off position.
2. Close the water tap.
• If you do not deactivate the appliance,
after a few minutes from the end of the
programme:
– All the indicators go off.
– The display shows one horizontal
status bar.
This helps to decrease the energy con-
sumption.
Press one of the buttons, the display and
the indicators come on again.
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and
on the door of the appliance. Stainless
steel becomes cool more quickly than
the dishes.
and bad washing results. The water softener
neutralises these minerals.
The dishwasher salt keeps the water softener
clean and in good conditions. It is important to
www.zanussi.com