Advertisement
General rules
The ACS880 should only be mounted where all the requirements defined in "Checking the installation Site"
are met.
Floor-Mount the Drive
1.
The cabinets are free standing and do require bolting in place.
2.
Leave some space at the side to allow doors to open sufficiently. The doors can open 120°. ABB
recommends minimum of 3 feet side to side spacing and 5 feet clearance on the back (see images
below).
Note: For leveling make height adjustments with metal shims between the cabinet bottom and the floor.
Note: It is recommended that you do NOT remove the lifting eyes of the cabinet. If you removed the lifting
eyes and the panel is intended for use as an IP54 installation, it is recommended that you install an IP54
listed solution in their place.
ACS880-0P SENSIA CE SUPPLEMENT [3AXD50000905423]
R9 enclosure
R11 enclosure
15
Advertisement
