Assembly Of External Irrigation System - Nouvag MD11 Operation Manual

MD 11
7. Insert the spike at the end of the tubing set into the irrigation fluid bottle and hang the bottle onto the
stand.
8. Open the roller clamp on the tubing set as far as it will go.
9. Open the bleed valve beneath the drip chamber.
10. Connect the control unit to the power socket.
Ensure that the operating voltage setting corresponds to the local mains voltage.
6.4

Assembly of external irrigation system

A
E
REF 1873
A) Connect the open end of the irrigation tube set (REF 1706) with the cooling pipe of the Contra Angle.
B) Attach white clip (REF 1881) to the tube set.
C) Attach white clip with tube set to the Contra Angle.
D) Connect the electronic motor with the Contra Angle.
E) Attach grey clip (optional, REF 1873) to the tube set.
F) Attach grey clip with tube set to the cable of the motor
G) Ready to use drill unit with attached external cooling system.
If required, secure additional clips to the motor cable.
MD 11, V2.0, Operating Instructions, REF 31665, V22/17
7
B REF 1881
F
8
C
9
EN
D
G
9