Cisco Dial NMS Implementation Manual page 107

Cisco systems basic dial nms implementation guide

Interface

Get system description

To test that a device responds to SNMP Get requests, follow these steps:

Select a device icon in the map (single click).

From the Fault menu, select Test IP/TCP/SNMP.

This action performs one ICMP echo, one TCP connection, and one SNMP get. SNMP is working if the

"OK" message appears under the SNMP Get field.

Table 32 describes the important fields in Figure 29.

Node

172.21.102.33

ICMP Echo

26 ms

TCP Connect

SNMP Get

Confirms the interfaces were successfully pinged.

Verifies that the system description information was collected, so

you can identify the software version running on the device.

The target loopback IP address of the Cisco device.

HPOV successfully pinged the device.

HPOV successfully made a TCP connection with the device.

HPOV successfully made an SNMP query to the device.