Table of Contents
Advertisement
FRONT PANEL CONTROL OVERVIEW
Digital Display
Speed Buttons
Mode Buttons
Power Switch
Control Buttons
ON/OFF (POWER)
This button controls AC power to the control unit.
DIGITAL DISPLAY & DIGITS
#1: (full left) shows the selected MODE for operation or programming.
#2: Indicates the Positioner travel SPEED in relative numbers from 0 to 9.
#3: Indicates an ". Or -" for a limit zone or a digit when programming in a high gear ratio.
#4,5,6,7: Indicates HEADINGS, Azimuth / Elevation / Polarity, in degrees and programming data.
"MODE" BUTTONS
The MODE buttons are used to cycle through and select among (5) operational or RUN modes and 10 PRESETS.
See RUN MODES and PROGRAM MODE details following this section.
"SPEED" BUTTONS
The SPEED buttons control the positioner's rate of speed in relative increments. "1" is the slowest speed, "9" is
the fastest. The top button increases the speed, the lower button decreases the speed. The lowest speed
available DEFAULTS to "1", but can be set to any number between "1" and "9" in the supplied M2 Setup Utility
Software. Speeds can be altered for travel in any of the run modes.
"CONTROL" BUTTONS
The "CW" and "CCW" or "UP" or "DOWN" buttons, activate the positioners' direction in MODE "0", MODE "1"
and MODE "2". These buttons are also used for "Auto Cal" and "Initial Cal Heading."
Advertisement
Table of Contents
Troubleshooting
