M2 Antenna Systems RC2800PRKX2SU Manual page 15

HEATER UNIT CONNECTIONS
Slide the prepared 2-Conductor Red & Black 16AWG wire through the cord grip from the front of
the panel. Route the Red wire to position "A" as shown below. Then route the Black wire to
position "B" as shown below. Tighten small flathead screws on the terminal strip. Place the front
panel onto the LSK enclosure and reinstall the (8) 8-32 screws. Tighten the cord grip nut on the
front of the panel.
Remove the (8) 8-32 screws from the front limit
switch panel.
1/4"
Prepare the provided 2-Conductor Red &
Black 16AWG wire. Remove (5-1/4") of
the outer grey jacket. Strip (1/4") of
insulation from both the Red & Black
wires as shown.
5"
A
B