Table of Contents
Advertisement
It is controlled via AT commands(GSM07.07 ,07.05 and SIMCOM enhanced AT Commands). And the design of
this shield allows you to drive the GSM & GPS function directly with the computer and the Arduino Board. It
includes a high-gain SMD antenna for GPS & GSM.
This GPS/GPRS/GSM shield uses an embedded SIM908 chip from SIMCom.Featuring an industry-standard
interface and GPS function, the combination of both technologies allows goods, vehicles and people to be tracked
seamlessly at any location and anytime with signal coverage.
Specification
Power supply: 6-12v
Low power consumption (100mA@7v - GSM mode)
Quad-Band 850/900/1800/1900MHz
GPRS multi-slot class 10
Support GPS technology for satellite navigation
Embeded high-gain SMD antennas for GPS & GSM
Directly support 4*4 button pad
USB/Arduino control switch
Board Surface:Immersion Gold
Size: 81x70mm
Pin Out
Advertisement
Table of Contents
Need help?
Do you have a question about the TEL0051 and is the answer not in the manual?
Questions and answers