Disposal And Recycling - Scheppach HP3000S Original Instruction Manual

Cleaning the float chamber (fig. N + O)
m Attention: Only remove the float chamber when the
engine is cold!
1. Close the fuel valve (24).
2. Loosen the drain plug on the float chamber and
drain the fuel into a suitable container.
3. Attach the drain plug again
4. Loosen the fastening screw of the float chamber
5. Unscrew the float chamber and radial seal and
thoroughly clean them in a non-flammable solvent
and let them dry. Check the radial seal for dents
and damage.
6. Screw both parts back on.
7. Screw on the fuel valve and check it for leaks.
Please provide the following information in the
event of any enquiries:
• Machine data - type plate
• Engine data - type plate
Important hint in case of sending the plates to a
service station:
Due to security reasons please see to it that the vibra-
tory plates are sent back free of oil and gas!
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Spark plug, oil, belt, rubber pad, air filter
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

14. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled.
The equipment and its accessories are made
of various types of material, such as metal and
plastic. Defective components must be disposed of as
special waste. Ask your dealer or your local council.
www.scheppach.com GB | 35