Factory Mode (Code Bypass Mode) - Volkswagen 5C6.035.160 Manual

2. Factory Mode (code bypass mode)

In order to make it possible to check the unit and the periphery during the mounting at the assembly line, the unit can
be unlocked by pressing the combination of keys. That sequence can be repeated up to 50 times. The unlock unit can
play for a timeout of 15 minutes, after this time the unit locks again.
The first entering of security code will deactivate this factory mode feature.
This feature is available during radio delivery default condition with K.30 ON, regardless of the condition of the Kl.15
Activation:
Initial state: Radio OFF/ON, Kl.30 ON,
1.
Press and hold right knob and then
2.
Short press left knob
3.
Display will show the numbers of factory modes used, then the radio frequency will appear in the display.
It is possible to have the Factory Mode deactivation with one of the following actions:
a. Switch radio off by pushing left knob once
b. automatic shutting off after operating time of the radio in bypass mode t = 15 minutes, regardless of the condition
of S-contact.
c. remove the battery power
d. activate of diagnosis mode via CAN message, radio switches to DIAG mode and upon terminating DIAG mode,
radio returns to bypass mode if still within 15 minutes of code-bypass operating time requirement, else radio goes to
"1000" state. If radio has not been decoded before, code bypass mode is still allowed if the number of times code
bypass used is < 50 times allowable limit.
e. activate of transport mode via CAN message, radio switches to low standby current mode and upon canceling
Transport mode, radio remains at low standby current mode or OFF mode. Upon power on, radio goes to "1000"
Prepared by Hector Gomez
HMI/ VWM DTEE / 52-222-2307414
DOC_HMI RADIO 2 DIN MIB-G LAM X1.8 revisada / 13/05/2011
Page 8 of 78