Anti-Theft Coding - Volkswagen 5C6.035.160 Manual

1. Anti-theft coding

Role of radio coding
Removing the unit from the vehicle (for example, if you take your vehicle to the dealership for service and requires
disconnecting the battery) will be necessary to recode the radio manually. If you install the radio in another vehicle,
the recode also must be restored manually.
If SAFE appears in the display after turning on the radio, you can operate again only by entering the correct code.
Note: This code number(4 digits) is written by hands on the label attached on the radio writing "****OK"
Turn on the radio, radio's sound is muted. The display shows SAFE. After two seconds 1000 appears in the
display.
Use the SK [1 to 4] buttons to enter the numeric code. Use the SK [1] button to enter the first digit numerical
code. Use the SK [2] button to enter the second digit and so on. The range of values for each of the 4 digits is 0
to 9. The digits are increased by 1 to 1 every time you short press the SK buttons. The value returns to 0 after 9.
After entering the entire code, short press SK 6 [OK] button, radio output's beep sound.
If the code has been entered properly, radio's audio is started immediately and then goes to FM 1 band.
Prepared by Hector Gomez
HMI/ VWM DTEE / 52-222-2307414
DOC_HMI RADIO 2 DIN MIB-G LAM X1.8 revisada / 13/05/2011
Page 6 of 78