Anti-Theft Coding - Volkswagen RMT200 User Handbook Manual

BDA 051 228 A BA Radio RMT 200.book Seite 106 Freitag, 20. Juli 2012 12:21 12

Anti-theft coding

The anti-theft coding prevents the reactivation of the device electronically when the it is removed by
unauthorised persons.
If "SAFE" appears in the display for a short time immediately after turning on the device and the "1000"
permanently, you have to enter the code number corresponding to the device to deactivate the
electronic lock.
Enter the code number
"SAFE" appears in the display after turning on the device and then "1000" after a short period.
By pressing the function button under the respective figure several times, the four digit code number can
be entered.
After entering the four figures, keep the
confirmed by an acoustic signal. Then the device is ready for operation.
Device card
The code and serial number is located on a device card supplied with the device. The device card must
be kept in a safe place. Never leave it in the vehicle. The device is only useful for thieves if they also
have the card!
Incorrect code number
If the incorrect code number is entered when unblocking the electronic lock, first "SAFE" appears
flashing in the display and then "1000" once again. Now the complete procedure can be repeated again.
The number of attempts already carried out will be shown to the left in the display. If an incorrect code
number is entered again, the device is blocked for approx. one hour. This means that it cannot be put
into operation for this period. The lock can be recognised by the continuous "SAFE" and the number of
attempts will be shown to the left in the display. After one hour – the device must remain switched on for
this purpose – the display goes out and you are able to unblock the electronic lock, as previously
described, once again. The cycle – two attempts, blocked for one hour – still applies.
If the device card with code number has been lost, please contact your Volkswagen partner.
Language settings
The display language can only be set in radio mode.
MENU
Keep pressing the
Press the respective function button for selecting the language.
Function button Language settings
ENG
English
PORT
Portuguese
ESP
Spanish
RUS
Russian
106
button pressed until the acceptance of the code has been
until the current language set is displayed.