Regulatory Notices; Fcc Class A Notice; Canadian Certification - Can Ices-3 (A)/Nmb- 3(A); Battery Cautions - Entrust nShield Solo Installation Manual

3. Regulatory notices

3.1. FCC class A notice
The nShield Solo and nShield Solo XC HSMs comply with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. The device may not cause harmful interference, and
2. The device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
users will be required to correct the interference at their own expense.

3.2. Canadian certification - CAN ICES-3 (A)/NMB- 3(A)

3.3. Battery cautions

Danger of Explosion if the battery is incorrectly replaced. The battery may only be
replaced with the same or equivalent type. Dispose of the used battery in accordance
with your local disposal instructions.

3.4. Hazardous substance caution

This product contains a lithium battery and other electronic components and materials
which may contain hazardous substances. However, this product is not hazardous
providing it is used in the manner in which it is intended to be used.

3.5. Recycling and disposal information

For recycling and disposal guidance, see the nShield product's Warnings and Cautions
documentation.
nShield® Solo and nShield® Solo XC Installation Guide 9 of 49