Advanced Setting; System Password; Bandwidth Control & Qos Setting - Vivotek 600AG User Manual

3.3. Advanced Setting

Under advanced settings, you will be able to configure the following:

21. System Password

22. Bandwidth Control / Qos Setting
23. DHCP Configuration
24. NAT Configuration
25. SNMP configuration
26. Wireless Security Setting
21. System Password
The default password to enter 600AG serial SMT is 0000. SMT-21 let the user change the
password to control 600AG. The new password will take in place on the next login.
( ( ( ( Note: Note: Note: The Web UI is ID: admin / PW: password Note: The Web UI is ID: admin / PW: password. . . . ) ) ) ) The Web UI is ID: admin / PW: password The Web UI is ID: admin / PW: password
In the case of forgotten password, the only way to enter SMT to control 600AG is by hard resetting
the 600AG to factory default, detailed in Chapter 5 of this manual. However, hard reset will erase all
the configurations that had on the 600AG and make all the setting back to factory default.
22. Bandwidth Control & Qos Setting