Table of Contents
Advertisement
2.3. Outdoor Installation
The 600AG can be mounted on the wall or an antenna mast as shown in the following：
Step 1 Compose the holder of the 600AG
Step 2 Connect the female end of the power cord into the PoE Injector, and then connect the male
end of the power cord into a power outlet. The red Power LED at the front of the PoE Injector will be
on.
Step 3 Connect RJ-45 Ethernet connector from the 600AG into the Power & Data Output Port on the
PoE. When the 600AG receives power over Ethernet cable, the 600AG will start its boot sequence
and the yellow Active LED at the front of the PoE will be on.
Step 4 Run Ethernet cable from Data Input Port（at the front of the PoE）to the Ethernet Port on
the PC or notebook.
Advertisement
Table of Contents
