ABB HT564586 Operation Manual page 48

Operation Manual / 4 Product description / A100-L
3 Commissioning
3.2.2 Checks before commissioning
Air filter mat (if present)
Check for damage and contamination.

Lubricating system
Contaminated oil
Serious damage to engine or property can be caused by dirt and solid mate-
rial particles in the oil.
CAUTION
At initial commissioning and after all service work, the complete lubricating

system must be thoroughly flushed with warm oil.
Use special running-in filters when running in the engine and after all ser-

vice work on the lubricating system.
Check that the oil filter is clean before commissioning.

Check the oil pressure in the oil supply pipes.

Warning plates
Check whether warning plates are present and legible.

Check whether the protective sheets have been removed.

3.2.3 Checks after commissioning (engine in idle mode)
Lubricating system
Check the oil pressure in the oil supply pipes.

Check oil inlet temperature.

The admissible values are specified in section Oil supply.
Gas, air and oil pipes
After starting the engine, check all gas, air and oil pipes for leaks.

© Copyright 2016 ABB. All rights reserved. HZTL4034_EN
Page 18 / 111
Revision F June 2016