Table of Contents
Advertisement
Function settings:
In the System Setting menu, select the item to be set by pressing the UP/DOWN key and press the OK key for editing.
Set the desired value by pressing the UP/DOWN key and press the OK key to confirm the adjustment.
6.26 System Settings - Stick Calibration
T h e stick cali brat i on fun cti on is use d to resto re th e data o f th e n eutra l pos it io n an d
endp oints, wh ich are c hanged for ce rtai n reas o n s after t he t ran s mi tte r ha s be en us e d for a long
time. Th e ST, T H and V R2 cha nne ls can b e recov ered by us in g th i s f un ctio n plea se refer to t he
chapter for stick cal ibrati on.
Function settings:
1.In the Stick Calibration menu, turn the direction handwheel left and right to the maximum and return it to the
neutral position; pull the trigger back and forth and return it to the neutral position; then turn VR2 left and right to the
maximum and return it to the neutral position; and finally press the OK key to confirm the calibration.
2.Carry out a test to confirm that all channel outputs set after calibration are functioning as expected.
6.27 System Settings - Firmware Update
Th e firmware update fu ncti on is used for sy n chro n izi n g th e s ystem to th e late st ve rsi on an d
exper iencing bette r fu nctions and se r vices when the f ir mwa re is u pgra ded by th e ma n ufa ct ure r.
Function settings:
Note: This function is only available in the FlySky Assistant software provided by FLYSKY.
1.In the Firmware Update menu, a dialog box will pop up. At this time, you can select YES by pressing the UP/DOWN
key and press the OK key to start the update session. The current menu will be closed directly once the update session
is completed.
2.Carry out a test to confirm that the transmitter functions normally after the update.
Note: Always ensure sufficient power supply for the transmitter when using this function.
19
Advertisement
Table of Contents
