Fly Sky FS-i6 Instruction Manual
  1. Manuals
  2. Brands
  3. Fly Sky Manuals
  4. Control Systems
  5. FS-i6
  6. Instruction manual

Fly Sky FS-i6 Instruction Manual

Digital proporational radio control system
Hide thumbs Also See for FS-i6:
Table of Contents

Advertisement

Quick Links

Proporational Radio Control
FS-i6
INSTRUCTION
MANUAL
Ie.4G4Af
N#2A

Advertisement

Table of Contents
loading

Related Manuals for Fly Sky FS-i6

Summary of Contents for Fly Sky FS-i6

  • Page 1 Proporational Radio Control FS-i6 INSTRUCTION MANUAL Ie.4G4Af N#2A...
  • Page 2 Digital Proporational Radio Control System Copyright 02015-2016(€678 Flysky RC model technology co., ltd FCC ID:N4ZFLYSKY16 Thank you for purchasing our product, an ideal radio system for beginners or experienced users alike. Read this manual carefully before operation in order to ensure your safety, and the safety of others or the safe operation of your system.

  • Page 3: Table Of Contents

    System Control FS-i6 Table of Contents 1. Safety 1.1 Safety symbols ......................1.2 Safety G u ide......................2. Introduction 2.1 System features. 2.2 Transmitter overview ..............................2.2.1 Transmitter antenna ..................... 2.2.2 Battery i nd icato r...............................8 2.3.1 Receiver...
  • Page 4 Choose sensors ................................. 21 Speed -di sta n ce ............................21 i-BUS setu p..................................2 1 Servos ferq................22 9.Package contents Product specifications Transmitter specification (FS-i6) 10.1...

  • Page 5: Fs-I6

    Control Receiver specification(FS-iA6) ..24 10.2 Appendix 1 FCC Statement FS-i6 1. Safety 1.1 Safety Symbols Pay close attention to the following symbols and their meanings. Failure to follow these warnings could cause damage, injury or death. 1.2 Safety Guide Do not fly at night or in bad weather like rain or thunderstorm.
  • Page 6 Do not use the product when the visibility is limited. Do not use the product on rainy or snowy days. Should any type of moisture (water or snow) enter any component of the system, erratic operation and loss of control may occur. Interference could cause loss of control.

  • Page 7: Introduction

    System Control 2. Introduction The FS-i6 transmitter and FS-iA6 receiver constitute a 6-channel 2.4GHz AFHDS 2A digital proportional computerized R/C system. It is compatible with fixed-wing,glider and helicopters. 2.1 System Features The AFHDS 2A (Automatic Frequency Hopping Digital System Second Generation) developed and patented by FLYSKY is specially developed for all radio control models.

  • Page 8: Transmitter Overview

    2.2 Transmitter overview Antenna Handle Lanyard hook Right gimbal Left gimbal Trim Trim Trim Trim DOWN CANCEL BIND KEY POWER Trainer jack/Update routine Battery compartment Lanyard hook interface...

  • Page 9: Transmitter Antenna

    FS-i6 Digital Radio System Proportional Control 2.2.1 Transimitter antenna For best signal quality, make sure that the antenna is at about a 90 degree angle Warning to the model. Do not point the antenna directly at the receiver. Never grip the transmitter antenna during operation. It significantly degrades Danger the RF signal quality and strength and may cause loss of control.

  • Page 10: Transmitter Battery Installation

    3.1 Transmitter Battery Installation Follow the steps below to install the battery: 1. Remove the battery compartment cover. 2. Insert 4 fully charged AA batteries, making sure that each battery is orientated correctly. 3. Replace battery compartment cover. 3.2 Receiver and servos Follow the steps below to connect servos to the receiver: Aux.

  • Page 11: Operation Instructions

    FS-i6 Digital Radio System Proportional Control 4. operation instructions After setting up, follow the instructions below to operate the system. 4.1 Power on Follow the steps below to turn on the system: 1. Check the system and make sure that: The batteries are fully charged and installed properly.
  • Page 12 Caution Make sure to disconnect the receiver power before turning off the transmitter. Failure to do so may lead to damage or serious injury.

  • Page 13: Fuction Description

    FS-i6 Digital Radio System Proportional Control Function description 5.1 Flight Controls (Mode 2) The sticks are used for controlling the aircraft, each stick has 2 functions. The right stick controls pitch and roll, the left stick controls throttle and yaw.

  • Page 14: Reverse

    3. To return default settings press and hold the "OK" seconds.Press and hold the"CANCEL"key to save. Throttle Up 5.3 End points Throttle Down 5.2 Reverse The reverse function changes a channels direction of movement in relation to its input. For example, if a servo has to be mounted upside down due to space restrictions within a model, this function can be used to correct its movement so that it matches up with the user controls.

  • Page 15: Display

    FS-i6 Digital Radio System Proportional Control Display This function displays the model's channel output in real time. Setup: 1. Hold the "OK" key to enable channel scrub mode. In this mode the channels will sweep though their entire range of motion.
  • Page 16 position. 3. Hold the "CANCEL" key to save and return to the previous menu. 4. To return to default settings press and hold the "OK" key for 3 seconds. until the channel returns to the center. Press and hold the "CANCEL" key to save.

  • Page 18: Dual Rate/Exp

    FS-i6 Digital Radio System Proportional Control Dual rate/exp. The dual rate/exp. function only applies to channels 1,2,4. Dual Rate: Dual Rate reduces or increases the difference between the highest and lowest possible value, for example if applied to the rudder, (set to a throw of 10cm) before changing the settings, when you move your stick to 1/2 you would get 5cm rudder movement, if you move the stick 1/4 of the way, the rudder will move 2.5cm, so at 100% there is a direct, linear relationship of stick movement and surface...
  • Page 19 Setup: Throttle Press the "OK" to change between points. Use the "UP" and "DOWN" keys to change point position. Hold the "CANCEL" key to save and return to the previous menu. To return a setting to default, press and hold the "OK" key for 3 seconds. Press and hold the "CANCEL"...

  • Page 20: Elevon

    FS-i6 Digital Radio System Proportional Control 5.10 Elevon The elevon function is used for planes that combine the elerons an alerons together. Setup: Ch2 sox Use the "UP" and "DOWN" to turn the function on and off. Use the "OK" key to change between settings.

  • Page 21: Throttle Hold

    assignment. Norma 1 3. To return a setting to default, press and hold the "OK" key Thro. hold SwD for 3 seconds. Press and hold the "CANCEL" key to save. 5.13 Throttle hold This function is used with gas powered models in order to stop stalls when not in use. Setup: Throttle 1.

  • Page 22: Helicopter Function

    FS-i6 Digital Radio System Proportional Control 6. Helicopter Functions 6.1 Pitch Curve This function is used for creating a curve that adjusts pitch control. Setup: Norma This function uses points for adjustment across the sticks range of movement. The horizontal axis represents the input.

  • Page 23: Model Name

    7.2 Model name This function renames the currently selected model. To change the name: Use the "Up" and "Down" keys to select a letter or number, then press the ok key to confirm. To save press and hold the "CANCEL" key. 7.3 Type select This function changes the type of the currently selected model, including airplane and helicopter with different types of swash plates.

  • Page 24: Student Mode

    FS-i6 Digital Radio System Proportional Control 7.7 Student mode Student mode is used when another system is connected as a master (Trai ner) when this mode is active all settings will be bypassed and the system will only function through the master.

  • Page 25: Rx Setup

    FS-i6 Digital Radio System Proportional Control 8 RX Setup 8.1 RF standard This menu allows you to change the communication protocol for the transmitter. The available protocols a re: Receiver RF Protocol AFHDS AFHDS 2A A3, A6,X6, iA4B, iA6, iA6B, iA10, iAIOB To Switching Between AFHDS 2A and AFHDS: 1.

  • Page 26: Choose Sensors

    FS-i6 Digital Radio System Proportional Control channels are listed in the failsafe menu. [Off] means that in case of a loss of signal, the corresponding servo will keep its last received position. If it displays a percentage, the servo will instead move to the selected position.

  • Page 27: I-Bus Setup

    8.8 i-BUS setup This function is used to set up the i-BUS module. The i-BUS module can be used to add servos to your model tha may be too far away from the receiver. Setup: Use the "UP" and "DOWN" keys to choose a channel and press "OK". Press the button on the i-bus module that corresponds to the desired output.

  • Page 28: Package Contents

    FS-i6 Digital Radio System Proportional Control 9. Package contents 2.4GHz transmitter FS-i6 2.4GHz rsceiver FS-iA6 FS-i6 User manual (CD) INSTRUCTION MANUAL USB cable 10 Product specifications 10.1 Transmitter specification(FS-i6) Channels Model type Fixed-wing/Glider/Helicopter RF range 2.4055-2.475GHz...
  • Page 29 RF power < 20dBm RF channel Bandwidth 500 1<Hz 2.4GHz system AFHDS 2A/AFHDS Modulation type GFSK Stick resolution 4096 low voltage alarm < 4.2V DSC port PS/2 PPM Chargeable None Antenna length 26mm*2 Weight 392g Power input 6V DC 1. 5AA*4 Transflective STN positive screen with backlight,128*64 Display Size...
  • Page 30 FS-i6 Digital Radio System Proportional Control Appendix 1 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of theFCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 31 Digital Proportional Radio Control System C 0678 FCC ID:N4ZFLYSKY16 http://www.flysky-cn.com Copyright 02015-2016 Flysky RC model technology co., ltd Edition: 2016-08-19...

Table of Contents