Figure 58. Installing an expansion card
5. Tilt the metal bracket and tighten the captive screw.
Next steps
1. If required, reconnect the cables to the expansion card.
2.
Install the air
shroud.
3. Follow the procedure listed in
Optional BOSS S2 module
Removing the BOSS S2 module blank
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the front
bezel.
Steps
Loosen the captive screw and pull out the BOSS S2 module blank from the system bay.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
71