Harman Kardon RCP 7 Owner's Manual page 11

Table 1 – Remote Control Codes
Source Input Product Type
(circle one)
Video 1 VCR, PVR
Video 2 Cable, Satellite
Video 3 TV
Video 4 TV
HDMI 1 DVD, VCR,
Cable, Satellite
HDMI 2 DVD, VCR,
Cable, Satellite
*
DVD DVD
CD CD, CD-R
Tape Cassette
*
Do not reprogram the DVD Source selector unless you are replacing
the DVD player included in the CP 65 system with another product.
7. After you have programmed a code set to operate a device, test
the functions to see which ones may be missing or not operating
correctly. You may "learn" individual key codes if you have the
device's original remote control by following the procedure below.
If you no longer have the device's original remote, you may still
connect it to the AVR 347.
Most of the button labels on the remote describe the button's function
when used to control the AVR 347 (gray labels) or DVD 48 (blue
labels). However, the button may perform a very different function when
used to control another device. Refer to the Remote Control Function
List, Table A1 in the Appendix, for a list of each button's functions with
the various product types.
If you wish, you may program macros, which are preprogrammed
code sequences that execute many code commands with a single
button press. You may also program "punch-through" codes, which
allow the remote to operate the volume, channel or transport controls
of another device without having to switch the remote's device mode.
See page 13 for instructions on these advanced programming
functions.
NOTE: The RCP 7 remote is preprogrammed to operate the
transport controls of the DVD 48 when the AVR or VID2 or VID3
device is selected. You may change this punch-through program-
ming at any time, as explained in the Advanced Functions section.
PROGRAMMING SOURCES
Remote Control Code
11