Refilling The Water Tank; After Every Steam Operation - Siemens CO565AGS0 Instruction Manual

Steam
en
Notes
If your water is very hard; we recommend that you
■
use softened water.
If you use only softened water, you can set your
■
appliance to the "softened" water hardness range.
Briefly press on the centre of the tank cover.
1.
The tank cover will open. The drip tray (left) and
water tank (right) can now be accessed.
Remove the water tank from the tank recess.
2.
Fill the water tank with cold water up to the "max."
3.
mark.
Place the water tank back into the tank recess and
4.
slide it in fully.
Close the tank cover.
5.
The steam function is ready to use.
22
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.

Refilling the water tank

The way the appliance responds if the water tank runs
dry when the appliance is in operation depends on what
operating mode it is in:
Steam mode: The appliance is stopped and a
■
message appears on the display.At the highest
steam setting, a tankful of water will last approx. 30-
40 minutes; at the lower steam settings, it will last
much longer.
Steam with microwave: The appliance is stopped. A
■
tankful of water will last approx. 50 minutes.
Grill with steam: The appliance continues to run in
■
grill mode; no message appears on the display. At
the highest steam setting, a tankful of water will last
approx. 3 hours; at the lower steam settings, it will
last much longer.
Actual times may vary from those specified.
Note:
Refill the water tank up to the "MAX" mark.
Open the control panel.
1.
Remove and refill the water tank.
2.
Insert the filled water tank and close the control
3.
panel.

After every steam operation

Moisture remains in the cooking compartment. Carefully
wipe out the drip channel and the cooking
compartment. Each time you cook using steam, we
recommend that you run the Rinse cleaning function ù
afterwards. Then empty and dry the water tank and drip
tray.
Remove limescale marks with a cloth soaked in
Note:
vinegar, then wipe with clean water and dry with a soft
cloth.
Emptying the water tank
Briefly press on the centre of the tank cover.
1.
The tank cover folds upwards.
Remove the water tank.
2.
Carefully remove the lid for the water tank.
3.
Empty the water tank, clean it with detergent and
4.
then rinse it thoroughly with clean water.
Dry all parts with a soft cloth.
5.
Rub the seal on the lid until dry.
6.
Allow the water tank to dry with the lid open.
7.
Place the lid on the water tank and push down on it.
8.
Slide the water tank in fully.
9.
Close the tank cover and briefly press on the centre
10.
of it.
The tank cover is locked.
Caution!
Do not dry the water tank in the hot cooking
■
compartment. This will damage the water tank.
Do not clean the water tank in the dishwasher. This
■
will damage the water tank.