Problems And Warning Signs - Janome DKS100 SE Instruction Book

Audible signal The buzzer sounds when:
Normal operation
Pip
Invalid operation
Pip-pip-pip
Pip-pip-peep
Buttonhole sewing completed
Malfunction
Peep
Warning sign
Clean the outside of the machine with a soft cloth. Do not use chemical solvent.
Store the machine in cool dry place.
Do not store the machine in area of high humidity, near a radiator or in direct sunshine.
It is not abnormal that a faint humming sound comes out from inside the machine.
LCD display and pattern selection keys may get warm when the machine has been used for hours.
Accumulated bobbin thread residues may cause auto thread cutting errors. Contact an authorized dealer or service
center to remove thread residues from inside the free arm cover.
Cause
The machine will not sew with the start/
stop button because the foot control is
connected.
The machine will not sew because the
presser foot is not lowered.
A buttonhole is sewn without lowering
the buttonhole lever.
The bobbin winder spindle is moved to
the right.
The machine is restarted too soon after
it has halted due to the overload.
Auto thread cutting error due to a
problem in the electronic components
or tangled threads in hook area.
The twin needle key is pressed when
the machine has been in the twin
needle sewing mode.

Problems and Warning Signs

Disconnect the foot control and start the
machine.
Lower the presser foot lifter and start the
machine.
Lower the buttonhole lever and restart the
machine.
Move the bobbin winder spindle to the left.
Wait for at least 15 seconds to restart. If
threads are jamming, remove the jammed
threads.
Remove the jammed threads in the hook area.
If the error occurs again after cleaning the hook
area, contact the service center or the store
from where the machine was purchased.
Press the twin needle key to return to the twin
needle sewing mode.
Or turn off the machine and change to the
single needle for normal sewing.
55
Try this