Drawing Up The Bobbin Thread - Janome DKS100 SE Instruction Book

q
w
e
r
START
STOP

Drawing up the Bobbin Thread

After using auto thread cutting or threading the bobbin
holder, you can start sewing without drawing up the
bobbin thread.
However, you need to draw up the bobbin thread when
sewing gathering stitches etc.
Remove the bobbin. Insert the bobbin into the bobbin
again and rethread the bobbin holder according to the
instructions on page 15, but leave a 10 cm (4˝) tail of
the bobbin thread as shown.
q Bobbin thread
NOTE:
Do not cut the bobbin thread with the thread cutter.
w Thread cutter
Raise the presser foot. Hold the needle thread lightly with
your left hand.
e Needle thread
Press the needle up/down button twice to lower and
raise the needle to pick up the bobbin thread.
r Needle up/down button
Pull both threads 10 cm (4˝) under and behind the
presser foot.
18