Table of Contents
Advertisement
according to the manufacturer's instructions. See the Safety instructions. that came with your system for more
information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If applicable, disconnect the power or data cables from the expansion cards.
4.
Remove the expansion card
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
Figure 108. Removing the system battery
2. To install a new system battery:
a. Hold the battery with the positive side facing up and slide it under the securing tabs.
b. Press the battery into the connector until it snaps into place.
106
Installing and removing system components
Safety
instructions.
Before working inside your
risers.
system.
Advertisement
Table of Contents
