Harman Kardon AVR 70 Owner's Manual page 22

AVR70 engelsk manual 11/01/98 11:57
9. When you have made your choice,
press and then
q
¤
return to the
M A I N M E N U
point the output levels for all channels
will be set to a reference so that the sound
level is the same from each speaker. This
compensates for the differences between
the speakers used and the distance each
speaker is from your listening position.
At this point you may wish to adjust the
rear channel delay time. See the Advanced
Features section later in this manual for
information on delay settings.
NOTE: Before setting the output levels it
is critical that the front panel bass
and treble controls
ı
center, or "12 o'clock" position. This
ensures accurate results.
10. At the
MAIN MENU
until the cursor is next to
>
. Press
SELECT r
TONE
continue.
11. When you press
SELECT
immediately hear a test noise from the
front left speaker. The on screen display
will change to a graphic representation of
each of the speakers in your room, with
one speaker position blinking. (Figure
#3, page 15) That speaker is the one
whose level is being set.
Side 16
System Configuration
to NOTE: This procedure will only operate if
SELECT r
. At this the AVR70 is in the
or
MOVIE
Modes. If the test tone cannot be selected,
select
MENU O F F
and check to see which surround
MENU
mode is indicated in the front panel
display. If it is not one of the modes
mentioned above, select one of the correct
modes, and then select the
point
MENU
and
SELECT
¤
resume the set up.
12. While seated in the primary listening
position in the center of the room, press
Ù
be set to their
SPEAKER v
the sound should now come from the
Center Channel speaker, and the icon for
that speaker will flash on the screen. Use
, press twice the
ADJUST
¤
buttons
w
TEST
to level of the test noise so that it appears to
be equal in level to the Front Left speaker.
you will 13. Press the
and repeat the procedure for the Front
Right and Surround channels. Each
time, use the
buttons
¤
the volume level so that all speakers
match, and then press
move to the next channel.
16
,
PRO LOGIC
DOLBY3 STEREO
in the
M AIN
MAI N
by pressing
TEST TONE
on the remote to
on the remote . Note that
and
ADJUST
⁄ ¤
on the remote to change the
button again,
SPEAKER
and
ADJUST ADJUST
⁄
on the remote to change
w
to
SPEAKER v
Subwoofers cannot be adjusted separately
by the Menu system. If neccessary adjust
by the volume poti of the subwoofer
amplifier.
NOTE: This test also serves as an
opportunity to verify that all speakers are
properly connected. If the sound from a
speaker location does not match the
location shown on the video and front
panel displays, turn the AVR70 off and
check the speaker wiring to make certain
that the speaker is connected to the
correct output terminals.
14. When all speakers appear to have an
equal volume, press the button
‹ q
the remote to complete the procedure.
NOTE: For a more accurate calibration of
the speaker output levels perform the test
outlined in steps 10 through 13 using a
sound pressure level (SPL) meter. It is
recommended that the output for each
channel measure 75 dB (C-weighted,
slow) on the meter.
CONGRATULATIONS! You have
completed a basic set up and you are now
ready to enjoy the finest in home theater
and music listening enjoyment.
on