Harman Kardon AVR 70 Owner's Manual page 21

AVR70 engelsk manual 11/01/98 11:57
Once the speakers have been placed in
the room and connected, the final step is
to enter the configuration information
and balance the speaker output levels.
Before proceeding further this is a good
time to review the installation section of
the manual to make certain that all
connections are properly made.
System Settings
1. Plug the unit into an AC wall outlet
and press the button on either
Power
the front panel or the remote
*
Note that the ring surrounding the front
panel switch will turn green, and the
front panel display will illuminate.
2. Check to see that the unit is configured
to the video broadcast standard in use in
your country by pressing and holding the
button on the front panel
OSD
more than three seconds. The front panel
display will indicate the current setting. If
the setting is not correct, if f.e. your
picture is only black and white, press the
button again until the correct standard
(PAL, SECAM or NTSC) is displayed.
3. Turn on the TV connected to the
receiver. Select the appropriate video
input on the TV.
NOTE: Although the unit will switch "S"
video signals, the on screen menus
control system is NOT visible on the S
video output.
4. Press any of the navigational arrow
buttons or the
SELECT r
the remote to bring the
on your video screen.
(Figure #1)
Side 15
System Configuration
5. Press the
¤
the on screen
SET U P MENU
6. At the
S E T U P M E N U
set the Center Channel Mode. The on
screen cursor will already point toward
>
this option when you select the menu.
Press the or
‹
one of these center channel options by
moving the cursor:
LARGE
are using large size full range center
channel speaker.
.
b
SMALL
center speaker is small sized.
:
NONE
not using a center channel speaker.
7. When you have made a center channel
for selection, press
)
next option. Note that the
should point to
8. This option enables you to lock the
configuration settings. This makes it
difficult for someone to inadvertently
change the settings by causing the
word
LOCK
SET UP MENU
changes can be made, the user must first
go to the
SET UP MENU
the system. Press the
to choose one of these options:
: Choose this option to lock the
LOCK
settings as described above.
button on
UNLOCK
up unlock the settings and enable them
MAIN MENU
to be changed without going to this
menu.
15
button three times until
cursor is pointing to
>
. Press .
SELECT r
(Figure #2),
buttons to choose
q
›
:
Choose this option if you
:
Choose this option if the
Choose this option if you are
Figure 1
to move to the
q
¤
cursor
>
.
SET UP LOCK
to appear at the top of the
. Before any further
Figure 2
and unlock
or buttons
q
‹ ›
: Choose this option to
Figure 3
M A I N M E N U
> I N P U T S E L E C T O R
S U R R O U N D M O D E
T E S T T O N E
S E T U P M E N U
M E N U O F F
S E T U P M E N U
L O C K E D
> C E N T E R M O D E L A R G E
S M A L L
N O N E
S E T U P L O C K L O C K
U N L O C K
R E T U R N T O M A I N M E N U
T E S T T O N E
O F F > O N