Table of Contents
Advertisement
Available languages
Available languages
•
To switch the appliance on, press the ON/OFF
button
1
, then turn the SmartSelect™ dial
desired setting.
•
To switch the appliance off, turn the martSelect™ dial to
off, then press the ON/OFF button.
NOTICE: Never leave the steam mop in one spot
on any surface for any period of time. Do not store
with a wet pad as this can damage your floor. Always
place the steam mop with the handle tube
upright position when stationary and make sure the
steam mop is turned off and unplugged when not
in use.
NOTICE: Always empty the water tank after use.
SmartSelect
TM
Dial (Fig. A)
The steam mop is equipped with a SmartSelect™ dial
which shows various hard surface cleaning applications. To
change the application, turn the SmartSelect™ dial until the
correct operating mode for your particular hard floor surface
is selected.
NOTICE: The dial has an "off" position. There will be
no steam flow when the dial is turned to this position
NOTICE: For garments and carpet, set the dial to to
the Wood/Laminate setting.
NOTICE: Do not use on any unsealed hard floor
surfaces. Additionally, on surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area of
the surface to be cleaned before proceeding. We
also recommend that you check the use and care
instructions from the floor manufacturer.
Using the SmartSelect™ dial, choose from one of the
following applications. The steam mop will select the
correct volume of steam required for your particular
cleaning operation.
Steam Mop Cleaning (Fig. A)
1. Place a cleaning pad
21
loop' side facing up.
2. Lightly press it down onto the cleaning pad.
3. Plug the steam mop electric cord into the outlet.
4. Press the ON/OFF button
seconds for the steam mop to heat up.
5. Turn the SmartSelect™ dial
activate the steam pump. After a few seconds steam
will start to come out of the steam floor head at the rate
corresponding to the SmartSelect™ Dial setting.
NOTICE: If the system has been run dry it may take up
to 30 seconds to prime the system on first use.
3
to the
6
in the
3
on the floor with the 'hook &
. It takes approximately 15
1
3
to the desired setting to
NOTICE: It takes a few seconds for steam to enter the
cleaning pad. The steam mop will now glide easily
over the surface to be sanitized/cleaned.
6. Push and pull the steam mop slowly across the floor to
thoroughly steam clean each section.
7. When you have finished using the steam mop, turn the
SmartSelect™ dial to off, unplug the steam mop, and
wait until the steam mop cools down (approximately
five minutes).
Steam Glove (Fig. L–O)
WARNING: Always use the steam glove as shown in
Figure L, with your hand inside the protective glove.
WARNING: Never attempt to use the steam glove by
gripping it externally as shown in Figure M. This will
result in scalding.
WARNING: Avoid using the steam glove in tight
corners as shown in Figure N.
WARNING: Should a problem occur during use, use
the quick release tab
15
glove from your hand as shown in Figure O.
Figure L
Figure M
Figure N
Figure O
English
to quickly remove the steam
7
Advertisement
Table of Contents
