Table of Contents
Advertisement
Available languages
Available languages
English
•
Attach the steam glove
12
the hose and steam glove section.
NOTICE: The SmartSelect™ dial is disabled when the
steam glove is attached.
Attaching a Cleaning Pad (Fig. P)
1. Insure micro-fiber steam glove is cool and not attached to
hand-held steam cleaner.
2. Fit a micro-fiber steam glove cleaning pad
steam glove
12
by attaching the velcro strips
back side of the cleaning pad, to the velcro pads
the underside of the steam glove (Figure P).
3. Press down firmly.
4. To use, follow instructions under hand-held
steam cleaning.
WARNING: Do not use the steam glove without a
cleaning pad in proper position.
Figure P
38
16
Hand-held Steam Cleaning (Fig. A)
1. Turn off and unplug steam mop. After allowing it to cool
down, remove the hand-held steam cleaner
steam mop body
.
10
2. Attach the required accessory.
3. Plug hand-held steam cleaner electric cord into
the outlet.
4. Press the ON/OFF button
seconds for the hand-held steam cleaner to heat up.
•
When you have finished using the hand held steam
cleaner, turn it 'OFF,' and unplug it. Wait until it cools
(approximately five minutes) before reattaching to
steam mop body.
Fabric Steamer (Fig. A, G, Q–S)
The fabric steamer allows you to steam and press clothes,
linens, and upholstery.
WARNING: Burn hazard, do not touch the metal
plate on the steam distributor. It will cause severe
injury. Allow plate to cool for at least 20 minutes
before removing or attaching any accessories.
WARNING: Burn hazard, do not use the fabric
steamer on clothes that are being worn.
1. Insure fabric steamer base
are cool and not attached to hand-held steam cleaner
8
as shown in the Attaching
16
to the
38
on the
on
39
39
12
2
from the
1
. It takes approximately 15
25
and steam distributor
26
2
2. Attach the fabric steamer base to the hose
Ensure the accessory has snapped securely into place.
3. Place the steam distributor directly on the fabric
steamer base so the two prongs
the base (Figure Q).
Figure Q
25
4. Snap the lint brush
Ensure that the four brush clips
of the fabric steamer base.
Figure R
5. To use, follow instructions under hand-held steam
cleaning. Move the brush and steam distributor along
the fabric to steam clean and remove wrinkles (Figure S).
NOTE: To ensure the steamer is safe for a fabric, first test it
in an inconspicuous area of the item you are to use it on.
Figure S
Carpet Refreshing (Fig. A)
WARNING: It is important to monitor the water level
in the water tank. To refill the water tank and continue
to clean, return the handle tube
position and turn the steam mop 'OFF'. Unplug the
unit from the wall outlet, and refill the water tank.
CAUTION: Never leave the steam mop in one spot on
any surface for any period of time.
1. Place the carpet glider
2. Lightly press the steam mop with attached cleaning pad
down onto the carpet glider (Figure T).
.
11
(Figure G).
40
clip securely onto
26
40
securely into place (Figure R).
27
41
are on the long side
41
6
to the upright
on the floor.
28
Advertisement
Table of Contents
