CDA CDI6242 Use And Maintenance page 28

AUTOMATIC FAULT WARNINGS AND WHAT TO DO
TROUBLE
POSSIBLE FAULT
CODE
Water inlet system failure
FF
Pressure system failure
F5
Continuous water input
F3
Inability to discharge water
F2
Heater error
F8
F1 Overflow
FE Faulty electronic card
F7 Overheating
F6 Faulty heater sensor
HI High voltage failure
LO Low voltage failure
The installation and repairing procedures should always carried out by the Authorised
Service Agent in order to avoid possible risks. The manufacturer shall not be held liable
for damages that may arise from procedures carried out by unauthorised persons. Repairs
may be carried out by technicians only. If a component has to be replaced, ensure that
only original spare parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and
put the user at considerable risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order
can be obtained from Customer Service for a period of at least 10 years from the date on
which your appliance was placed on the market within the European Economic Area.
WHAT TO DO
Make sure the water inlet tap is open and water is flowing.
Separate the inlet hose from the tap and clean the filter of
the hose.
Contact for service if the error continues.
Contact for service.
Close the tap and contact for service.
Water discharge hose and filters may be clogged.
Cancel the program.
If the error continues, contact for service.
Contact for service.
Unplug the machine and close the tap.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
EN - 28