Table of Contents
Advertisement
36
www.raider.bg
NOTE: (1) Service more frequently when used in dusty areas.
(2) These items should be serviced by an authorized dealer.
WARNING: Do not touch engine components because they are warm during use and up to 30
minutes after use, risk of burn injuries.
CAUTION: Use only original parts from the manufacturer..
11.1
Changing oil
Drain the oil while the engine is still warm to assure
rapid and complete draining
•Remove the oil filler cap and drain the oil.
•Refill with the recommended oil and check the level.
Oil capacity: 0.6 L
(1)
DRAIN PLUG
(2)
OIL FILLER CAP
(3)
UPPER LEVER
Wash your hands with soap and water after handling used oil.
NOTE: Please dispose of used motor oil in a manner that is compatible with the environment. We
suggest you take it in a sealed container to your local service for reclamation. Do not throw it in the
trash or pour it on the ground as the oil concerning the toxicity.
11.2 Air Cleaner Service
Refer to 6.4
11.3 Fuel Strainer Cup Cleaning
WARNING: Gasoline is highly flammable and explosive under certain conditions. Do not smoke
or allow flames of sparks in the area.
Turn the fuel valve to the OFF position and unscrew the fuel
strainer cup and the O-ring anti-clockwise. Wash the removed
parts in solvent, dry them thoroughly and reinstall them securely.
Turn the fuel valve ON and check for leaks.
(1) O-RING
(2) FUEL STRAINER CUP
11.4 Spark plug service
Recommended spark plug: LG F6TC
To ensure proper engine operation, the spark plug must be
properly gapped and free of deposits.
•Remove the spark plug cap.
WARNING: If the engine has been running the muffler will be
very hot. Be careful not to touch the muffler.
•Visually inspect the spark plug. Discard it if the insulator is
cracked or chipped.
•Measure the plug gap with a feeler gauge. The gap should be
0.7-0.8mm (0.028-0.031 in), Correct as necessary by bending the
side electrode.
•Attach the plug washer, thread the plug in by hand to prevent
cross-threading.
•Tighten a new spark plug 1/2 turn with the wrench to compress
the washer if you are reuse a plug, it should only take 1/4-1/2 turn
after the plug seats.
CAUTION: The spark plug must be securely tightened. An
improperly tightened plug can become very hot and possibly
damage the engine. Never use a spark plug with an improper
heat range.
11.5 Clutch Cable Adjustment
Measure the free play at the lever tip.
Free play: 3-8mm (0.1-0.3 in)
If the free play is incorrect, loosen the lock nut and turn the
adjusting bolt in or out as required.
(1) LOCK NUT
(2) ADJUSTING BOLT
After adjustment, tighten the lock nut securely. Then start the
engine and check for proper clutch lever operation.
Advertisement
Table of Contents
