Table of Contents
Advertisement
Precautions and Safety Instructions
General Precautions
Avoid storing or using the mixing console in conditions of excessive heat or cold, or in positions where it is likely to be
subject to vibration, dust or moisture. Do not use any liquids to clean the fascia of the unit: a soft dry cloth is ideal.
Avoid using the console close to strong sources of electromagnetic radiation (e.g. video monitors, high-power electric
cabling): this may cause degradation of the audio quality due to induced voltages in connecting leads and chassis.
Caution! In all cases, refer servicing to qualified personnel.
Handling and Transport
The console is supplied in a strong carton. If it is necessary to move it any distance after installation it is recommended
that this packing is used to protect it. Be sure to disconnect all cabling before moving. If the console is to be regularly
moved we recommend that it is installed in a foam lined flightcase. At all times avoid applying excessive force to any
knobs, switches or connectors.
Power Cable
Always use the power supply cable supplied with the mixer: the use of alternative cables may cause damage and voids the
warranty.
Warning! In the event of an electrical storm, or large mains voltage fluctuations, immediately switch off
the mixer and unplug from the mains.
Signal Levels
It is important to supply the correct input levels to the console, otherwise signal to noise ratio or distortion performance
may be degraded; and in extreme cases, damage to the internal circuitry may result. Likewise, on all balanced inputs avoid
sources with large common mode DC, AC or RF voltages, as these will reduce the available signal range on the inputs.
Note that OdBu =0.775V RMS.
Refer to the Specifications section for details of input and output levels.
Mains Installation
General Wiring Procedures
To take full advantage of the excellent signal to noise ratio and low distortion of Soundcraft consoles, care must be taken
to ensure that incorrect installation and wiring does not degrade the performance of the desk. Hum, buzz, instability and
Radio Frequency interference can usually be traced to earth loops and inferior earthing systems. In some areas, especially
heavily industrial areas, the incoming mains earth will not be adequate and a separate technical earth for all the audio
equipment must be supplied. However, check with your local electricity supply company to ensure that safety regulations
are not infringed or negated.
The successful, hum free, installation of a system requires forethought, and the establishment of a set of ground rules,
which must be consistently adhered to at all stages of installation.
9
Advertisement
Chapters
Table of Contents
