Download Print this page
SoundCraft DPS-2 User Manual
SoundCraft DPS-2 User Manual

SoundCraft DPS-2 User Manual

Power supply

Advertisement

Soundcraft D D PS-2 2 P P ower S S upply

Advertisement

loading
Need help?

Need help?

Do you have a question about the DPS-2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SoundCraft DPS-2

  • Page 1 Soundcraft D D PS-2 2 P P ower S S upply...
  • Page 3: Table Of Contents

    Soundcraft D D PS-2 2 P P ower S S upply Contents Contents Safety Symbol Guide Approvals and Notice Warranty Important Safety Instructions - Cautions Warnings Connecting up Dimensions viii Pin Outs of DC Output Connector DPS-2 Power Supply...
  • Page 4: Safety Symbol Guide

    Symbols should be read carefully. CAUTIONS Must be followed carefully to avoid bodily injury. WARNINGS Must be observed to avoid damage to your equipment. NOTES Contains important information and useful tips on the operation of your equipment. DPS-2 Power Supply...
  • Page 5 Soundcraft shall not be liable for loss or dam- age whatsoever arising from the use of information or any error contained in this manual.
  • Page 6: Warranty

    Equipment has been properly installed in accordance with instruc- tions contained in Soundcraft’s manual; and b) the End User has notified Soundcraft or the Dealer within 14 days of the defect appearing; and c) no persons other than authorised representatives of Soundcraft or the Dealer have effected any replacement of parts maintenance adjustments or repairs to the Equipment;...
  • Page 7 ON again. If the mains fuse fails repeatedly this may be because an electrical safety hazard exists. The unit must be taken out of service and referred to the Soundcraft dealer from where the equipment was purchased.
  • Page 8: Warnings

    Clean only with a dry cloth. l Do not block any of the ventilation openings. Install in accordance with the manu- facturers instructions. RM1d Console Ensure that only the DPS-2 Power Supply Unit is connected to the RM1d console. DPS-2 Power Supply...
  • Page 9: Connecting Up

    The locking ring should be firm, but not tight. Connect an IEC type mains cable with the plug fused at 3 AMPS, to the mains input socket on the DPS-2. Connect the other end to the nearest plug socket and switch on the power to the DPS-2.
  • Page 10: Dimensions

    DIMENSIONS viii DPS-2 Power Supply...
  • Page 11 PIN-O O UTS O O F D D C O O UTPUT C C ONNECTOR DPS-2 Power Supply...
  • Page 12 Soundcraft shall not be liable for loss or dam- age whatsoever arising from the use of information or any error contained in this manual.