Lamona LAM3410 Instructions And Installation page 6

Built-in Single Fan Oven
• Repair procedures must always be performed by qualified service
agents. The manufacturer shall not be held responsible for damages
arising from procedures carried out by unauthorised persons, which
may also void the guarantee.
• Be careful when using alcoholic drinks in your dishes. Alcohol evaporates
at high temperatures and may cause fire since it can ignite when it
comes into contact with hot surfaces.
• Do not heat closed tins and glass jars in the oven. The pressure that
would build-up in the tin/jar may cause it to burst.
• Do not place any flammable materials close to the product as the sides
may become hot during use.
• WARNING FIRE RISK: Do not place
aluminium foil, baking trays or cook on
the base of this oven, doing so will cause
permanent damage to your appliance and
cabinetry with the potential risk of fire.
• Keep all ventilation slots clear of obstructions,
as this may cause premature failure of the
oven element.
• Parts of the appliance may become hot during
or immediately after use. Care should be taken
to avoid touching the heating elements, and
components inside the oven which maybe hot.
Always allow sufficient time for the oven to cool.
• Do not allow the oven to cool with the door open. Even if the appliance
door is only open a little, front panels of adjacent units could become
damaged over time.
• If the door seal is very dirty this can prevent the door from closing
properly during use, resulting in possible damage to adjacent furniture
and poor efficiency. Always ensure the door seal is clean.
• Always use heat resistant oven gloves when putting dishes in or removing
dishes from the hot oven.
• Do not use the product if any door glass is removed or damaged.
• Rear surface of the oven may get hot when it is in use. Make sure that
the electrical connections do not contact the rear surface; otherwise,
connections may be damaged.
• Do not trap the mains cable and do not route it over hot surfaces. The
cable insulation may melt and cause a fire as a result of a short circuit.
• Make sure that the product function knobs are switched off after
every use.
6 www.howdens.com
LAM3410 LAM3411