Installation - Heath Zenith Secure Home DualBrite 4541 Manual

Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes,
turn the power off for one minute, then back
on. After the calibration time the control will
be in the AUTO mode.
D B
®
ual rite
Light comes on half bright for selected time af-
ter dusk (Off, 3 hr., 6 hr., until dawn).Selecting
OFF disables this feature.The motion sensing
features will continue to work as described
in this manual. If motion is sensed, the light
turns on full bright for the ON-TIME (1, 5, or
10 minutes) then returns to dim mode.

INSTALLATION

WARNING: Turn power off at circuit
breaker or fuse. Place tape over circuit
breaker switch and verify power is off
at the fixture.
IMPORTANT: Do NOT use with dimmers
or timers.
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
1. Remove two decorative nuts.
2. Remove mounting plate.
3. Tighten mounting screws finger tight.
4. Attach mounting plate to junction box.
This fixture comes with a universal mounting
bracket. It is pre-assembled on the fixture to
fit the majority of junction box applications.
ON-TIME Switch at
1, 5, or 10 minutes
Flip light
switch off for
one second
then back on*
Dimmer Control
Decorative Nut
Ground Screw
Wire Path
Bracket
Mounting
Screws
Wire Path
Fixture Screws
Note: We recommend having an assistant
help hold the lantern assembly during the
wiring process.
2
Mounting Plate
Mounting Screw
Junction Box
Mounting Plate
Ground Screw
200257-02