Installation - Heath Zenith LED Lighted Push Button with Keyfinder Light 598-1281-02 Owner's Manual

Installation

IMPORTANT: DO NOT install addi-
tional diode(s) to push button. Additional
diode(s) will cause chime to malfunction.
1. Using a small screwdriver, push in tab
on bottom of push button to remove
back (see Figure 1).
2. Insert wires through hole in center of
push button back. Attach back to wall
with screws provided (see Figure 2).
Figure 1 - Remove Push Button Back
Figure 2 - Attach Back to Wall
 598-181-0