Powering The Homebase - Honeywell Dolphin 9900 User Manual

USB Port
This USB Port is full-speed and 2.0 compliant. Using a USB cable, you can connect the
HomeBase to a peripheral device, such as a desktop computer or printer. When the Dolphin
terminal is seated in the terminal well, it is connected to the peripheral device via the
HomeBase. The USB port on the HomeBase requires that you use ActiveSync 4.1 or higher.
RS-232 Port
Use a 9-pin, RS-232 cable from Honeywell to connect this port to a peripheral device for RS-
232 data communication. For more information, see
5.
DC Power Jack
Use a power cable from Honeywell to supply power to this power jack. For more information,
see

Powering the HomeBase

Powering the HomeBase
The terminal requires 9.5 Volts DC input for communications and battery charging; the Honeywell power
cable contains a power adapter that converts the power source voltage accordingly. Only the power
adapter cable from Honeywell converts the voltage appropriately.
Honeywell recommends that you leave the Dolphin HomeBase connected to its power source at all times,
so that it is always ready to use.
1. Connect the Honeywell power cable to the DC jack on the rear panel of the HomeBase.
2. Connect the Honeywell power cable to the power adapter.
3. Plug the power adapter cable into the power source. The HomeBase is now powered.
11 - 4
on page 11-4.
Rev B
7/9/08
HomeBase Serial Connector
Dolphin® 9900 Mobile Computer
on page 11-
User's Guide