Chapter 1 - Agency Information; Label Locations; Led Safety Statement; Infrared Led Safety Statement - Honeywell Dolphin 9900 User Manual

1
Agency Information

Label Locations

Dolphin 9900 terminals meet or exceed the requirements of all applicable standards organizations for
safe operation. However, as with any electrical equipment, the best way to ensure safe operation is to
operate them according to the agency guidelines that follow. Please read these guidelines carefully
before using your Dolphin terminal.
Laser Safety Label
If the following label is attached to your product, it indicates the product
contains a laser engine or laser aimer:
Laser Eye Safety Statement: This device has been tested in
accordance with and complies with IEC60825-1: 1993+A1+A2 and 21
CFR 1040.10 and 1040.11, except for deviations pursuant to Laser
Notice No. 50, dated July 26, 2001. LASER LIGHT, DO NOT STARE
INTO BEAM, CLASS 2 LASER PRODUCT, 1.0 mW MAX OUTPUT:
650nM.
Caution - use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.

LED Safety Statement

The LED output on this device has been tested in accordance with IEC60825-1 LED safety and certified
to be a Class 1 LED device.
The maximum power outputs for each diode are as follows:
• Illumination LED: 194.0 uW, wavelength: 626nm+/-30nm
• Aimer laser (5300 engine): 360.1 uW, wavelength: 655nm
• Aimer LED (5100 engine): 81.6 uW, wavelength: 526nm+/-30nm

Infrared LED Safety Statement

Caution - Do not view directly with optical instruments.
The maximum power outputs for the IR LED is 145.1 uW. LEDs are pulsed at a frequency of 115,200 Hz
with a duty cycle of 18.75% where the "ON" time of a single pulse is 1.6275 x 10

UL and cUL Statement

UL and cUL listed: UL60950-1 and CSA C22.2 No. 60950-1-03.
Dolphin® 9900 Mobile Computer User's
Guide
Compliance Label
Rev B
7/9/08
LASER LIGHT. DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
1.0 mW MAX OUTPUT: 650nM
IEC60825-1:1993+A1+A2
Complies with 21 CFR 1040.10 and 1040.1 1
except for deviations pursuant to Laser
Notice No. 50, dated July 26, 2001.
-6
seconds.
1 - 1