Cisco 7507 Quick Start Manual page 38

Install Field Replaceable Units (FRUs)
The console display indicates whether or not the operation was successful. A series of exclamation points (!!!!)
and [OK] (as shown in the preceding example) indicates that the operation was successful. A series of periods (.
. .) and [timed out] or [failed] indicates a failure due to a network fault or an incorrect server name, address, or
filename). The following is an example of a failed attempt to boot from a remote server:
Booting Router-confg ..... [timed out]
If the display indicates that the process was successful, as shown in Step 6, proceed to the next step.
If the display indicates that the process failed, verify the name or IP address of the remote server and the filename,
and repeat the preceding steps. If the process fails again, contact your network administrator.
Step 7
Enter the show startup-config command
36
to confirm that the configuration file was
retrieved correctly. Look at the first line
for the configuration file size. Compare it
with the file you retrieved from the TFTP
server to confirm that it is correct.
Following is an example:
Router# show startup-config
Using 1186 out of 126968 bytes
!
version 12.0(9)S
hostname Router
!
Router#
Step 8
To ensure that the startup configuration
file stored in NVRAM is the default
running configuration file used by the
system, enter the copy
system:running-config
nvram:startup-config command:
Router# copy system:running-config
nvram:startup-config
Router#
%SYS-5-CONFIG_I: Configured from memory by
console
Router#
This completes the process for retrieving the
configuration file for the RSP.