Cisco 7507 Quick Start Manual page 14

Cisco router quick start guide

Hide thumbs Also See for 7507:

Step 5

Use a screwdriver to tighten the captive installation screw on the top of the power supply.

Note

For DC-input power supplies, refer to the "Install the DC-Input Power Supply" section on page 13 to

complete this procedure.

Step 6

Push the cable retention clip away from the power supply receptacle, and push the power cable in

until the cable retention clip snaps into place.

Step 7

Connect the opposite end of the power cable to an appropriate power source.

Step 8

Repeat Step 1 through Step 7 to install the second power supply (optional).

Table of Contents