Back Panel; Supplying Power To The Quadcharger Device - Honeywell Dolphin 7600 User Manual

Back Panel

Power Supply Connector
Use this connector to attach the power supply to the QuadCharger device. The universal
power supply accepts input voltages between 90-265 volts.
Power Switch
Toggle the power switch to turn the QuadCharger device on and off.

Supplying Power to the QuadCharger Device

Use the power adapter cable that comes with the QuadCharger device so that the input voltage is
adjusted appropriately.
1. Locate the AC power adapter cable and plug it into the power source.
2. Connect the power cable to the power adapter.
3. Connect the power cable to the power supply connector on the back of the QuadCharger device.
4. Press the power switch to the ON position.
5. The device performs the following power-up diagnostic routine for each slot indicated by the Status
LEDs:
• All ON Orange
• delay (500ms)
• All ON Red
• delay (500ms)
• All ON Green
• delay (500ms)
• All OFF
11 - 2
Power Supply Connector
Rev A
5/23/2008
Power Switch
Dolphin® 7600 Mobile Computer
User's Guide