Nauticam 83211 Instruction Manual

Instruction Manual for M67 Mounting
Ring/Bayonet Mounting Ring for WWL-1
PN# 83211/83212
F
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognise the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera.
Each product is individually inspected and water pressure tested to ensure
optimum quality.
Please read this manual carefully before using the product, this will maximise
its performance as well as its lifetime.
W
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use. This warranty only applies to products purchased from authorised
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authorized
service centre(s). Please note that this warranty only applies when the product
is purchased in the territory where the service centre is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthorised modifications and/or repairs of our products will automatically
invalidate the warranty.
P C
ACKAGE ONTENTS

M67 Mounting Ring / Bayonet Mounting Ring for WWL-1

Thumb Screws x 8

Positioning Pins x 4
I P
DENTIFICATION OF ARTS
Positioning pins (x4)
M67 Mounting Ring
PN# 83211 M67 Mounting Ring for WWL-1
Thumb screws (x8)
Bayonet Mounting Ring
PN# 83212 Bayonet Mounting Ring for WWL-1
*PN#83211 is used as an example in this instruction manual, PN#83212 will
be slightly different in term of appearance.
Unscrew the eight thumb screws, and remove them from the back of the lens.
Remove the bayonet mounting ring, keep the 4pcs black positioning pins in
position.
Thumb screws (x8)
Locate the 4pcs sockets on the M67 mounting ring, and align them with the 4
positioning pins on the WWL-1 and install accordingly.
Positioning pins (x4)
C M R
HANGE THE OUNTING ING
Current as of 2022-05-23