Nauticam 87515 Instruction Manual

Instruction Manual for Instruction Manual for Instruction Manual for Instruction Manual for
M67 Mount to EMWL Focusing Unit M67 Mount to EMWL Focusing Unit M67 Mount to EMWL Focusing Unit M67 Mount to EMWL Focusing Unit
PN
F F F F
OREWORD OREWORD OREWORD OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the
requirements of professional as well as amateur underwater
photographers and fulfill them through the innovative designs of
our products. We strive to achieve a high level of user-friendliness
by allowing stress-free installation and easy operation of all
important functions of the camera.
Please read this manual carefully before using the product, this will
maximize its performance as well as its lifetime.
W W W W
ARRANTY ARRANTY
ARRANTY ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for
consumer use. This warranty only applies to products purchased
from authorized NAUTICAM dealers and does not extend beyond
the original retail purchaser.
To return your product for service, please contact your regional
authorized service center(s). Please note that this warranty only
applies when the product is purchased in the territory where the
service center is located.
NAUTICAM does not hold responsibility for damage, of any nature,
to any equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or
the inability to capture images even if it is due to the
malfunctioning of our products.
Unauthorized modifications and/or repairs of our products will
automatically invalidate the warranty.
I I I I P P P P
DENTIFICATION OF DENTIFICATION OF DENTIFICATION OF DENTIFICATION OF ART ART ART ART
Screw Holes (x 6)
M67 Thread
*Remark: the illustrators in this manual may differ from the actual product.
# 87515
Locating Pin Holes (x 3)
Spare Locating pins (x 3)
Spare Thumb Screws (x 6)
C C C C M67 M67 M67 M67
HANGE TO HANGE TO HANGE TO HANGE TO MOUNT MOUNT MOUNT MOUNT
1. Remove the six thumb screws from the focusing unit as
shown.
2.
Remove the bayonet mount ring.
Note that there are three small black cylindrical locating
pins. All 3 pins should remain on the focusing unit.
3. Place M67 mount ring onto the focusing unit it seats on the
focusing unit.
Current as of 2020-08-26