“1000 Hours Control” test Care instructions for leather straps Master Grande Ultra Thin and Master Ultra Thin Master Ultra Thin 41 Master Ultra Thin Date International Guarantee Limited Warranty (United States of America and Canada) Guarantee for Australia Customer Service...
INTRODUCTION We would like to thank you for the confi- dence you have placed in Jaeger-LeCoultre. Our Maison has applied all its expertise and exacting standards to the creation of this model. We invite you to consult the operating in- structions and hope your Jaeger-LeCoultre timepiece brings you great joy.
WATER RESISTANCE Your Jaeger-LeCoultre watch is water- resistant to 5 bar. Its water resistance can be identified by the symbol and/or the engraving: “5 bar”...
Page 4
- have the watch’s water resistance checked by an authorised Jaeger-LeCoultre retailer at least once every two years. It is essen- tial to have such a check carried out each...
Page 5
- avoid using the controls, push-piece, or time-setting crown while under water, or outside the water, if the watch is not yet dry after immersion. - restore the time-setting crown and the push-pieces to their normal positions, (or where applicable, close the compression keys) after every manipulation.
“1000 HOURS CONTROL” TEST The Jaeger-LeCoultre Manufacture pays close attention to the quality and to the final checks of its watches. The 1000 Hours Control is a series of in- ternal qualification tests for each of the models in our collection, as well as inter- nal tests on the production of your watch, which go beyond official timing tests.
in temperature and atmospheric pressure, ability to withstand shocks and magnetic fields, as well as water resistance. CARE INSTRUCTIONS FOR LEATHER STRAPS 1. Keep the leather strap in a dry place 2. Avoid contact with water, cosmetics, perfumes, alcohol and oily materials 3.
MASTER GRANDE ULTRA THIN AND MASTER ULTRA THIN 1 Hour hand 2 Minute hand 3 Crown 4 Small seconds hand...
Page 9
TECHNICAL SPECIFICATIONS - Automatic mechanical movement, ultra-thin, Jaeger-LeCoultre Calibre 896. - Vibrations/hour: 28,800 - Power reserve: approximately 43 hours MOVEMENT Jaeger-LeCoultre Calibre 896 WINDING A few clockwise turns of the crown will suffice to start the watch. It will then au-...
Page 10
tomatically wind up when you wear it. Please note that the crown does not lock when winding, even when the watch is ful- ly wound. SETTING THE TIME Pull the crown out to position 1. The movement is then locked (“stop sec- onds”...
Page 11
At the stroke of the hour, push the crown back in to position 0. The watch starts running again.
Page 12
MASTER ULTRA THIN 41 1 Hour hand 2 Minute hand 3 Crown...
Page 13
TECHNICAL SPECIFICATIONS - Automatic mechanical movement, ultra-thin, Jaeger-LeCoultre Calibre 898C. - Vibrations/hour: 28,800 - Power reserve: approximately 43 hours MOVEMENT Jaeger-LeCoultre Calibre 898C WINDING A few clockwise turns of the crown will suffice to start the watch. It will then au-...
Page 14
Please note that the crown does not lock when winding, even when the watch is ful- ly wound. SETTING THE TIME Pull the crown out to position 1. The movement is then locked (“stop sec- onds” function). For an accurate time set- ting in seconds, stop the second hand at 12 o’clock.
MASTER ULTRA THIN DATE 1 Hour hand 2 Minute hand 3 Crown 4 Central seconds hand 5 Date...
Page 16
TECHNICAL SPECIFICATIONS - Automatic mechanical movement, ultra-thin, Jaeger-LeCoultre Calibre 899. - Vibrations/hour: 28,800 - Power reserve: approximately 38 hours MOVEMENT Jaeger-LeCoultre Calibre 899 WINDING A few clockwise turns of the crown will suffice to start the watch. It will then au-...
Page 17
Please note that the crown does not lock when winding, even when the watch is ful- ly wound. SETTING THE TIME Pull the crown out to position 2. The movement is then locked (“stop se- conds” function). For an accurate time setting in seconds, stop the second hand at 12 o’clock.
Page 18
SETTING THE DATE Pull the crown out to position 1. Move the hands clockwise until the de- sired date is displayed and then push the crown back into position 0. Note: never try to adjust the date between the hours of 8.30 p.m. and 3.30 a.m. This is because the automatic date-change mechanism is already in action between these times.
Page 19
Australia, Jaeger-LeCoultre products must be purchased exclusively from authorised Jaeger-LeCoultre retail- ers or from Jaeger-LeCoultre Boutiques. Maintenance and repair work must be en- trusted to an authorised Jaeger-LeCoultre retailer, a Jaeger-LeCoultre Boutique, or an authorised Jaeger-LeCoultre Service Centre. If these conditions are not met, the manufacturer’s guarantee does not...
Any part found by our technical services to be defective as a result of a manufac- turing defect will, at the sole discretion of Jaeger-LeCoultre, be repaired or replaced free of charge. The Jaeger-LeCoultre In-...
Page 21
Guarantee is valid only if the guarantee certificate enclosed with this booklet has been duly completed, dated, stamped, and signed by the authorised Jaeger-LeCoultre retailer or the Jaeger- LeCoultre Boutique, which sold you your watch. The Jaeger-LeCoultre International Guar-...
Page 22
Jaeger-LeCoultre retailer, Jaeger- LeCoultre Boutique, or an authorised Jaeger-LeCoultre Service Centre (for further information please see your User Manual). For quartz watches, this guarantee does not cover the battery life. As a consumer, you may have legal rights under applicable national legislation gov- erning the sale of consumer goods;...
LIMITED WARRANTY (UNITED STATES OF AMERICA AND CANADA) The following Limited Warranty applies to Jaeger-LeCoultre products sold or pre- sented for warranty repairs in the United States of America and Canada only. TERMS AND CONDITIONS OF AEGER-LE OULTRE LIMITED WARRANTY...
Page 24
Jaeger-LeCoultre retailer or the Jaeger-LeCoultre Boutique, which sold you your watch. This Jaeger-LeCoultre Limited Warranty does not cover defects resulting from ac- cidents, mishandling, or incorrect, abusive use (for example, knocks, dents, crushing,...
Page 25
Jaeger-LeCoultre retailer, a Jaeger- LeCoultre Boutique, or an authorised Jaeger-LeCoultre Service Centre (for fur- ther information please see your User Manual).
Page 26
The liability of Jaeger-LeCoultre is limited solely and exclusively to repair or replace- ment under the terms and conditions stat- ed herein. Jaeger-LeCoultre shall not be liable, by virtue of this Limited Warranty...
You are also entitled to have the goods repaired or replaced, if goods fail to be of acceptable quality and the failure does not amount to a major failure. This Jaeger-LeCoultre Guarantee gives you additional rights and remedies un- der the Australian Consumer Law and...
Page 28
Every Jaeger-LeCoultre product is made and tested to meet the Jaeger-LeCoultre quality standards. Nevertheless, should your Jaeger-LeCoultre product prove defective, please contact the Jaeger- LeCoultre retailer or Jaeger-LeCoultre Boutique indicated on your guarantee certificate;...
Page 29
Jaeger-LeCoultre will remedy these identi- fied defects free of charge for up to two (2) years from the date of purchase. Thereafter, Jaeger-LeCoultre will repair any defective product or part subject to a service charge. The Jaeger-LeCoultre Guarantee does not...
Page 30
It is essential to have the water resistance checked by an authorised Jaeger-LeCoultre retailer, a Jaeger-LeCoultre Boutique, or an author- ised Jaeger-LeCoultre Service Centre at least every two years, and in any event, prior to any period of intensive use. Please refer to the operating instructions for fur- ther details.
Page 31
In Australia, a claim under the Jaeger- LeCoultre Guarantee may be sent to Richemont Australia Pty Ltd, provider of the guarantee service, at the address be- low or as specified above: Richemont Australia Pty Ltd PO Box 4780 Sydney, NSW 2001 Tel: +1 800 71 0665 Email: client.relations.asia@jaeger- lecoultre.com...
CUSTOMER SERVICE A Jaeger-LeCoultre timepiece is a high- precision instrument that operates 24 hours a day, or 8,760 hours a year. There- fore, it is essential to have it serviced reg- ularly in order to guarantee its good work- ing order and its durability. If significant variations occur in the settings, it may be necessary to have the movement serviced.
Page 33
Jaeger- LeCoultre watches and clocks. In certain cases, especially for operations requiring special tools and parts, the Ser- vice Centres will send your watch to the Jaeger-LeCoultre Manufacture in Switzer- land to have the necessary work carried out.
Need help?
Do you have a question about the Master Ultra Thin Date and is the answer not in the manual?
Questions and answers