Table of Contents
Advertisement
Press the refill button located at the back of the pump assembly
until soap starts coming out of the soap dispenser spout. This
operation can also be done using the soap dispenser remote
control Refill function.
5.
Note : Once the soap in the soap tank has reached the bottom line
the soap tank should be refilled. To refill the soap tank please refer
to steps 1-5.
REMOTE CONTROL FUNCTIONS (SOLD SEPARATELY)
The soap dispenser remote control can adjust the dispenser's settings. To use the remote control hold it in front
of the sensor at a distance of 10-15cm (4-6").
Attention: The remote control will not operate out of the recommended range (too close or too far).
The remote control can be used to adjust the following functions:
1-SOAP QUANTITY
The 1-4 drop keys allow the user to choose the desired soap quantity.
0.7 to 0.9cc
Indication: continuous blinking of the light in the sensor eye.
2-ADJ
This function resets the sensor back to factory
settings. Indication: 2 blinks of the light in the sensor
eye.
3-TEMPORARY OFF FUNCTION
This function temporary disables the dispenser. Use
this function to perform maintenance in front of the
sensor without activating the system (for example:
cleaning).
The soap dispenser will shut off for one minute after
this button is pressed once. To return to normal
operation before the minute is over, press the On/Off
button again. Indication: OFF – 2 fast blinks, ON – 4
fast blinks
4-FILL THE SOAP TANK
1.2 to 1.6 cc
Version 1, 17 March 2021, Page 7 of 12
1.6 to 1.9 cc
2.1 to 2.3 cc *
Advertisement
Table of Contents
