Table of Contents
Advertisement
3. Assemble corrugated tube:
-
Assemble the corrugated tube to the soap
dispenser base.
-
Ensure corrugated tube is kept in place whilst
tiling.
-
Insert the wall rosette through the soap
dispenser base.
5. Soap bottle:
-
Install soap bottle support assembly using
screws and wallplugs provided.
-
Connect soap dispensing tube to soap bottle
using Quick connecting fitting supplied in
packaging.
-
Connect the soap pump connector to the
matching connector from the sensor.
Version 1, 17 March 2021, Page 5 of 12
4. Assemble spout:
-
Cut / remove the temporary soap dispenser base
cover.
-
Fix the soap dispenser spout by inserting the
nipple into the soap dispenser base and then
tightening the screw.
-
Remove the protective sticker covering the
sensor. Keep away from the sensor range and
check that no objects are in front of the sensor.
-
Pull the two points connector, soap dispensing
tube and the power supply connector out of the
soap dispenser base, and through the corrugated
tube.
6. Battery box:
-
Open battery box by unscrewing screws on the lid
and insert 6xD Alkaline Batteries in battery box.
-
Close the lid and tighten the screws.
-
Install the battery box on the wall underneath the
sink using screws and wallplugs provided.
-
Connect the battery connector.
7. Test:
-
Wait about 10 seconds before you put your hands
within the sensor range to avoid entering the
adjustment mode.
-
Test the soap dispenser.
Advertisement
Table of Contents
